I bought a Summit Viper SD a couple years ago and boy oh boy, was the paint bad for that particular production run. After a few uses, it was chipping everywhere and after a couple years, there were big spots of bare aluminum so I decided to throw a wire brush on a 4" grinder and finish the job then repaint it. I figured I'd go ahead and get the Molle II Straps and foot rest as well. Right now, the Molle harness is tied in to the frame with the straps that came with it but I'll more than likely drill it and secure it with hardware and eliminate all the straps all together. I just wanted to see where it needed to be and how it felt so I tied it all in temporarily. I'll be doing the same with the top section this weekend. With this and the Hazmore seat it should come out pretty nice.
I'll post pics of both halves when it's done.